![]() ![]() The part cooling and heatsink fan should also pull away at this stage. It is expected that there will be some resistance, there are some plastic clips that require a little force to overcome. These are accessed from the back of the mount.ģ. Remove the x2 M3 dome head screws that fasten the plastic cover to the hotend mount. Turn off the power and unplug the kettle lead.ĭo not attempt disassembly when the hotend is still hot.ĭo not attempt disassembly when the printer is connected to a power source.Ģ. ![]() X2 M2.5x10 screw (supplied with bl touch)ġ. The fan duct is a remix of the Permanoob version that can be found here. We cannot be held responsible for damages caused by the use, misuse or abuse of our products. Your HotEnd and your printer are your responsibility.If you are unsure double check the rating on your power supply. Connecting 12v parts to a 24v power supply can result in overheating, component damage, or fire.All of our current heater cartridges should have the voltage and wattage laser engraved on the cartridge. Make sure you have ordered and received the correct voltage heater and fan to match the power supply of your printer.The firmware modification is not optional it is a mandatory step, For more information please see: Hemera Firmware Guides.Please see the Hemera Max Temperature Rating Guide for more information. ![]()
0 Comments
Leave a Reply. |